D-Link DES-1008D Podręcznik Użytkownika

i DES-1008D 8-Port 10/100Mbps Dual Speed Ethernet Switch User’s Guide Rev. 02 (Mar. 2000) 6012-9600011 Printed In Taiwan RECYCLABLE

h 2 INTRODUCTION This chapter describes the features of the DES-1008D and some background information about Ethernet/Fast Ethernet switching technolo

3 Ethernet packets at the MAC address level of the Ethernet protocol transmitting among connected Ethernet or Fast Ethernet LAN segments. Switching

h 4 Features The DES-1008D was designed for easy installation and high performance in an environment where traffic on the network and the number of u

5 ?? Uplink/ MDI-II (media dependent interface) port for uplink to another switch, hub or repeater. ?? Store and forward switching scheme capabilit

h 6 Unpacking and Setup This chapter provides unpacking and setup information for the DES-1008D. Unpacking Open the box and carefully unpacks its con

7 IDENTIFYING EXTERNAL COMPONENTS This section identifies all the major external components of the DES-1008D. Both the front and rear panels are sho

h 8 Full-Duplex/Collision (Full-Duplex/Collision) This LED indicator lights green when a respective port is in full duplex (FDX) mode. Otherwise, i

9 ? MDI-X Jacks: Use these jacks to connect stations to the hub. These are MDI-X (Medium-Dependent Interface, Cross-wired) jacks, which mean, you c

h 10 CONNECTING THE DES-1008D This chapter describes how to connect the DES-1008D to your Fast Ethernet network. In each of the following figures, th

11 A. 10BASE-T Hub For a 10BASE-T hub, the DES-1008D LED indicators should light up as the following: “Full-Duplex/Collision” indicator is OFF. “10

LIMITED WARRANTY D-Link Systems, Inc. (“D-Link”) provides this limited warranty for its product only to the person or entity who originally purchas

h 12 A. Using straight cable When using straight cable, this is done from the uplink (MDI-II) port of the DES-1008D (DES-1008D A) to any of the 10Mbp

13 RJ-45 PIN SPECIFICATION When connecting your DES-1008D to another switch, a bridge or a hub, a modified crossover cable is necessary. Please revi

14 The standard RJ-45 receptacle/connector The following shows straight cable and crossover cable connection: Straight cable for DES -1008D

15 TECHNICAL SPECIFICATIONS General Standards IEEE 802.3 10BASE-T Ethernet IEEE 802.3u 100BASE-TX Fast Ethernet ANSI/IEEE Std. 802.3 NWay Auto-neg

16 Physical and Environmental DC inputs DC5V/2.4A Power Consumption 1.2 watts. (max.) Temperature Operating: 0? ~ 50? C, Storage: -10? ~ 70? C Hu

iii to the defective Hardware. The Warranty Period shall extend for an additional ninety (90) days after any repaired or replaced Hardware is delive

REGISTRATION CARD MAY AFFECT THE WARRANTY FOR THIS PRODUCT. Submitting A Claim. Any claim under this limited warranty must be submitted in writing

v surge, and cosmetic damage; and Any hardware, software, firmware or other products or services provided by anyone other tha n D-Link. Disclaimer of

specific legal rights and the product owner may also have other rights which vary from state to state.

vii FCC Warning This equipment has been tested and found to comply with the regulations for a Class B digital device, pursuant to Part 15 of the FCC

TABLE OF CONTENTS ABOUT THIS GUIDE......1 PURPOSE ...

1 ABOUT THIS GUIDE Congratulations on your purchase of the DES-1008D. This device integrates 100Mbps Fast Ethernet and 10Mbps Ethernet network capabi