D-Link DSL-302T Przewodnik Instalacji Pobierz pdf (Strona 11)

3.2. Troubleshooting Internet access

If you can not access the Internet:

1. Log into the modem via 10.1.1.1 or 10.1.1.2 (USB connection). Select Quick Configuration page

and set Refresh Rate to 3 sec.

2. At the bottom of this page look for Connection Status. You will see one of the following messages

there:

VC Down No ADSL signal detected.

• Make sure you have telephone cable connected to the

DSL-302G modem;

• Make sure ADSL filter is not connected to the line

which goes to the modem;

• Check with your ADSL provider if ADSL service has

been enabled on your line

LCP

No Response

• Double-check the Connection Type and Encapsulation

settings with your ISP

Auth Fail Authentication problem.

• Make sure your username and password are correct;

• Double-check the Security Protocol settings

(PAP/CHAP) with your ISP

Connected Connection established

• Reboot your computer and try accessing the Internet

again

• Try specifying IP address and DNS settings on your

computer as described above

More information on DSL-302G can be found at http://www.dlink.com.au/products/broadband/dsl302g/

Technical support information on DSL-302G:

http://www.dlink.com.au/tech/drivers/files/modems/dsl302g.htm

D-Link Australia Technical Support can be contacted on 1300 766 868 or [email protected]

1 2 ... 6 7 8 9 10 11

Brak uwag

D-Link DSL-302T Przewodnik Instalacji Strona 11